Sell AVINAS AV305 Waffle Maker Non Stick Surface Toaster Baker (ADAPTOR NOT INCLUDED) best price

Power & Ready to cook indicators Vertical storageCord winder Non-stick coated cook plates Voltage: 220V-50Hz Power: 750W Plug Type: EU Plug 【Features】 ● Clean the baking plates with a damp cloth or sponge. -Slightly grease the baking plates with a little butter or cooking oil. -Plug in the sandwich maker and heat up the plates until the GREEN READY TO COOK PILOT LIGHT GOES OFF. The sandwich maker is ready for use NOTE: WHEN USING THE SANDWICH MAKER FOR THE FIRST TIME , A FINE SMOKE HAZE MAY RESULT . THIS IS NORMAL BECAUSE OF THE INITIAL HEATING OF THE INTERNAL COMPONENTS . making toasted sandwich ● Put the mains plug into the wall socket . The red power light and green power light will both illuminate to show that the sandwich maker is heating. -Prepare the bread and the filling for your sandwich while sandwich maker is pre-heating. -Wait until the GREEN ON PILOT LIGHT GETS OFF , THE SANDWICH MAKER IS THEN AT THE CORRECT TEMPERATURE FOR USE . -To obtain an even golden brown result , YOU CAN SLIGHTLY BUTTER THE SIDE OF THE BREAD IN CONTACT WITH THE PLATE . -Lay the slices of bread with the buttered side on the lower cooking plate , place your filling and cover with the second slices of bread with buttered side up . You can toast only one sandwich if you wish. For optimal result, fillings should be placed well within the sandwich slices. ● Lower the upper cooking plate carefully onto the bread until the sandwich maker is tightly clamped. -OPEN THE SANDWICH MAKER AFTER 2-3 MINUTES AND CHECK WHETHER THE TOASTED SANDWICH IS SUFFICIENTLY "BROWN" . THE COOKING TIME REQUIRED TO OBTAIN CRISP BROWN SANDWICHES DEPENDS ON THE TYPE OF BREAD , FILLINGS AND YOUR PERSONAL TASTE -Use non-metallic utensils (e.g Wooden spatula) to remove the toasted sandwich maker. Do not use sharp or abrasive kitchen utensils. -Unplug the sandwich maker from the wall socket after use . ●NOTE:DURING COOKING , THE GREEN READY TO COOK PILOT LIGHT CYCLES ON AND OFF TO MAINTAIN THE APPLIANCES AT THE CORRECT TEMPERATURE.