Philippines

Iron & Steamer Type

How to use the hand-held steam brush correctly:
(1) Turn and remove the water tank. (Just rotate a certain angle, you can also operate according to the prompt signs on the water tank)

(2) Open the water filling cover and fill it with tap water, tilt the water slightly, fill the box, and then fill it with water. At least one-third of the water in the tank. (Please pay attention to the up and down sequence of the water tank, install the water tank according to the mark on the bottom of the water tank)

(3) Connect the electrical appliance to the power socket and turn on the power. The indicator light at the end of the steam brush head will light up. Wait for the steam brush to warm up. When the indicator light is off, the preheating is completed and the indicator light will light up intermittently. This is to keep the preheating state, you can start to use, please press the steam button to get steam. The product can be ironed vertically or horizontally, and the clothes can be hung and ironed directly, or the clothes can be ironed flat.

(4) After using the product, please empty the water. It is recommended to continue to power on and heat for about 10 seconds until there is no
Until the steam comes out, then turn off the power and let it cool down naturally

The indicator light is on, but no steam comes out:
(1) Check whether the steam button is pressed.
(2) Whether to add water to the water tank.
(3) The burning time is too long. It is recommended to cool down after a few minutes of power failure and use it again.

Why does the steam nozzle leak:
The steam brush is not fully heated. Wait for the steam brush to be fully heated before it can be used.

Reasons for water tank leakage:
Water will not leak under normal use, please check the following reasons
(1) The filling cap of the water tank is not closed properly. Pay attention to the top of the water tank
Follow the sequence below to install the water tank according to the signs on the bottom of the water tank, and close the water inlet of the water tank tightly
After-sales service:
1. If you receive a defective product, please contact me and I will provide you with a solution

2. If you buy the wrong product and don't like it and need to return it, the product has no traces of use and the packaging is not damaged. Support returns and exchanges, and the freight needs to be borne by the buyer

3. If you need inspection payment, please contact me, I will tell you which products support inspection payment 

4. If you don’t know how to use this product, please contact me and I will tell you how to use this product

5. MiElectronics provides high-quality product quality, and product service 

6. MiElectronics will launch new products from time to time, pleas