Sell ✾TPM50 for Toyota Lexus Scion TPMS Loop Reset Tire Pressure Monitoring System Unlock Tool OBD2 Scann best price

OBDResource TPM50 For Toyota Lexus Scion TPMS Loop Reset OBDResource TPM50 For Toyota Lexus Scion TPMS Loop Reset, works with most toyota up to 2009 ,doesn't work with camry, Land Cruiser models. Attention: This tool is just used for TPMS LOOP MODE ; Not for TPMS Relearn or TPMS Sensor Programming (you need extra TPMS Relearn tool or programming tool) . Note: The TPM50 tool is to be used along with a properly formatted TPMS scan tool! Systems of a Toyota/Lexus Scion TPMS system to become locked in loop mode: If your TPMS tool gives you the error message of: "cannot WRITE the ID 's to the control module" while performing a TPMS relearn on a Toyota/Lexus/Scion, the vehicle's TPMS system is stuck in a "loop mode". What causes a Toyota/Lexus/Scion TPMS system to go into “loop mode?” – If the TPMS reset switch is pressed (in those cars equipped with it) AFTER a TPMS sensor replacement and BEFORE the new sensor(S) are programmed to the Control Module by a TPMS scan tool, the vehicle can become stuck in a loop. The vehicle is searching for older TPMS IDs that are no longer there. – Driving the vehicle with the TPMS warning symbol on for an extended period of time. Features of OBDResource TPM50 For Toyota Lexus Scion TPMS Loop Reset: ●TPMS Reset tool for Toyota vehicles with the TPMS warning light stuck in the "ON" position. ●The missing or broken sensors or the blank sensors installed but not yet been programmed, these will cause vehicles to become stuck in a loop. ●This TPMS loope reset tool can clean TPMS warning light when stuck in loop. ●Accurate and fast! Plugs into OBD II connection and hold button to reset, No pin jumping required with the OBDResource Reset Tool. ●Quickly reset the TPMS light and continue with the TPMS repair. Avoid an expensive trip to the Toyota Dealer for repair! The difference between OBDResource TPM50 TPMS Loop Reset Tool and another one May be cann't hold WRTRS50's button when plug in this obdii port ,because the button on the surface, may be covered For TPM50, this would never happen. Background Toyota vehicles prior to 2009 are equipped with a Tire Pressure Warning Reset Switch can be used for initialization . When the button is pushed and held for more than 3 seconds, the vehicles receivers are open and looking for the currently stored TPM IDS. What if there is a missing or broken sensor? What if there are new sensors on the vehicles that haven’t yet been programmed? This will cause these vehicles to become stuck in a loop, searching for TPM IDS that are no longer there. OBDRESOURCE has developed the Toyota Loop Reset Tool to handle this issue. How to tell the vehicle is in the “loop”? When a Toyota vehicle is stuck in the “loop” the technician will not be able to write IDS using the OBD COMMS, and the tool will error out. To verify it is a result of theloop conditionthe technician can selectthe READ IDS option, which will connect and read out the IDS.