Sell Switch Films for Mechanical keyboard Switch repair HTV inter-axial pad structure adapts to MX Switch Film inter-axial paper best price

Function: dustproof, increase sealing, improve stable experience Process: Double layer is HTV+PC, new single layer is white MDI HTV like silicone MDI like sponge Highlights: Flexible solution to the problem that PC material cannot be placed in the small shaft body Adhesion is more stable than PC material, and it is not easy to move between shafts The soft material can solve the unevenness caused by the roughness of the shaft cover to a certain extent Principle: Customized special soft HTV material. In theory, a soft anti-aging material such as HTV can improve the sealing problem caused by uneven shaft cover, and buffer the vibration conducted by the upper cover, avoiding traditional stickers and PC material cannot solve the problem of dust ingress caused by flat airflow caused by rough shaft cover. In order to prevent crushing and deformation, the inter-axle pad has been changed to a large sheet, which is stacked on top but is convenient to take This product is based on Jiadalon, JWK structure design, other spindle stems may be twisted, function does not interfere The thickness of the two models is roughly the same, but the performance parameters are different, suitable for different people Single layer thickness 0.14mm, double layer thickness 0.16mm, after installation, reduce the thickness according to the concave and convex surface of the shaft seat Comparison of single-layer and double-layer parameters The new single layer: opaque white MDI, the material is like a sponge, it has good elasticity and can be installed repeatedly and is not easy to deform. There is no need to distinguish between the front and the back, but the fit and sealing are not as good as the double layer, and the moisture resistance performance is also the same as that difference. Double-layer version: Transparent HTV + PC double-layer composite material. After inserting and installing, it can produce a good fit according to the tolerance and uneven surface of the shaft cover. The sealing and cushioning effect is higher than the single-layer version. It is recommended that the frosted surface face down to the shaft seat and the reflective surface face up to the shaft cover. It is not recommended to install and use repeatedly, because the first installation has already formed uneven surface deformation with the shaft at that time. *If you are just to solve the shaking, the effect of the two is the same