Sell READY STOCK Suitable for 3D Printer Accessories Automatic Leveling Sensor best price

description:1. Simple: 3DPress can be easily applied due to its small size and simple structure. Gathering information and firmware settings will be an easy task, because 3dPress works as usual with automatic bed leveling sensors. 2. Intelligence: Self-test: Push the three times to test when the power is Alarm: LED light flashes, if a problem is found in self-check or surgery If you choose 3dtouch, the 3D printer will be a top-notch masterpiece and give you a pleasant experience. 4. Innovative electromagnetic: super power saving, in idle state, and whether the promotion is pulled out or retracted, there is no current flowing solenoid vae, and the standby current of the entire device is lower than 15ma average, while in working state, while walking Suddenly about 100ms, the device flows under 300ma. Low power consumption even further reduces Joule heating, preventing thermal problems. 1. Bed width selection: 3dPress does not use any light, nor is it close to (inductive/capacitive) sensors.3dPress provides high precision through Hall effect control. Therefore, the bed material can be freely selected. 2. Optimized structure: larger volume, 3dPress is a technology-intensive person. The generated size can be set larger than other existing automatic bed level sensors. feature:3D-Press is a fully automatic universal 3D printer hot bed leveling probe (automatic leveling probe). Its advantages are simplicity, compactness, high precision, good compatibility, and compatibility Product name: Automatic leveling sensor 3d-Press wiring: wiring 3Pin: black (-, GND) red (+5V) blue (control signal); 2PIN: black (-, GND) yellow (Zmin) colour: picture color Material: ABS+metal Package Contents: 1*sensor 1*probe 2*M2.5 screws 2*M2.5 nuts 1*Dupont wire 2pin female to female 1*Dupont wire 3pin female to female Precautions: Some 3D printer motherboards have insufficient 5V power supply and may require an external 5V power supply, which shows that the probe is difficult to push out, or the logic circuit protection main control restarts during operation. If encountered, it is generally recommended to use a DC-DC step-down ule to take power from the main power supply. Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.