Sell Printer accessoriesSuitable for 3D Touch Automatic Leveling ule Auto Bed Leveling 3D Printer Accesso best price

1. Simple: 3Dtouch can be easily applied due to its small size and simple structure. Gathering information and firmware settings will be an easy task because 3dtouch works as usual with automatic bed leveling sensors. 2. Intelligence: Self-test: Push the three times to test when the power is. Alarm: LED light flashes, if a problem is found in self-check or surgery 3. High precision: The standard deviation of 3dtouch in repeatability is about 0.005mm, which is accurate. If you choose 3dtouch, the 3D printer will be a top-notch masterpiece and give you a pleasant experience. 4. Innovative electromagnetic: Ultra-saving electricity in the idle state, and whether the promotion is pulled out or retracted, there is no current flowing in the solenoid vae, and the standby current of the entire device is lower than 15ma average, while in the working state, while the feet are walking, suddenly Approximately 100ms, under 300ma flow device. Low power consumption even further reduces Joule heating, preventing thermal problems. 5. Bed width selection: 3dtouch does not use any light, nor is it close to (inductance/capacitance) sensors. 3dtouch provides high precision through Hall effect control. Therefore, the bed material can be freely selected. Optimized structure: larger volume, 3dtouch is a technology-intensive person. The generated size can be set larger than other existing automatic bed level sensors. Its advantages are simple, compact, high precision, good compatibility, and compatible with all bed surface materials, such as glass, metal, wood, plastic, acrylic, etc. Precautions: Some 3D printer motoards have insufficient 5V power supply, which may require an external 5V power supply, which shows that the probe is difficult to push out, or the logic circuit protection main control restarts during operation. If encountered, it is generally recommended to use a DC-DC step-down ule to take power from the main power supply. 1. +5V and GND should not be connected reversely for a long time, it may burn 2. Please try to keep away from strong magnets, motors, fans, and other magnetic components 3. Accily hitting the probe aluminum rod may damage or affect the detection accuracy 4. Adjusting or reassembling the set screw of the probe requires thread glue 5. Please avoid deformation of the shell when installing the probe 6. Pulling the aluminum rod hard will damage or affect the detection accuracy Colour: as shown Material: ABS+metal Package Contents: 1 x probe 2 x M2.5 screws 2 x M2.5 nuts 1 x 2pin female to female 1m Dupont cable 1 x 3pin female to female 1m Dupont cable Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.