Sell ✣ﺴPC817 4-way optocoupler isolation board voltage converter adapter module 3.6-30v best price

Description: This module is used when it is necessary to isolate the control in actual work and voltage conversion. It can realize 3.3V or 5V control 3.3---30V voltage level interface, after the control terminal input high level is turned on, the controlled terminal will also conduct to the ground, and the port changes from the original high level to the low level. For the friend of the single-chip or PLC, it is only necessary to judge when the output port is low. The photoelectric isolation has strong anti-interference ability, and the combination control of many different devices can be realized later, such as triode, MOS tube, and small power relay module. If it is a pulse signal, please note that the limit of 817 is below 3KHZ. If the control signal is greater than 3KHZ, please do not use this module, it will not work properly. Parameter: 1, the drive terminal signal voltage: 3.3-24V 2, the output voltage range: 3.3-30V (output current depends on the specific situation, but the maximum is not 10MA, the total power is certain, the voltage and current are inversely proportional) 3, through the jumper cap can achieve whether the output is high potential output or low output. 4, the board above 2 / 4 817 are independent, can achieve simultaneous control of different voltages, etc. 5: board size: length: 48mm; width: 38mm; long side hole distance: 42mm; wide side hole distance: 32mm 1. It can realize low level driving high level and realize voltage conversion. 2. Using this module, the IO voltage of the MCU can be graded to achieve isolated drive between different voltage levels. 3. Through the selection of the jumper cap of each channel, it is possible to achieve separate control whether it is shared with the input. The jumper cap is shorted so that the negative terminal of the output terminal is connected to the negative pole of the power supply (G in the figure). 4. Each channel has an independent power indicator, which can be directly driven by the IO port of the MCU. The input terminal is 5V high, and the 3-5MA current can be driven. Application: 1. MCU output level To drive the motor When the inductive device such as the motor is isolated, anti-interference protects the circuit of the MCU. 2. The output level of the single-chip microcomputer is low, and the driving voltage of the driven module is high. For level matching, for example, some PLC input should have 24V voltage and can be converted by this module. 3. For the inverter, the input signal can be inverted. 4. Used for high voltage detection, for example: the output signal level of a sensor is 12V. The voltage of the single chip is 5V. This module can be used for isolation detection.