Sell Aquarium DIY CO2 Atomizer Fish tank CO2 Generator System External BubbleReaction Diffuser For best price

Fish tank new CO2 external atomizerInstructions for use1: Install the product on the outlet pipe of the filter bucket, and then open the filter.It is recommended to tilt the air pipe connection downward during installation. If the air duct connection is facing up and there is air inside the product, loosen the metal cover of the acrylic glass and vent it slightly, then tighten it immediately after venting.2: Install the carbon dioxide equipment and air pipe, open the bubbler fine adjustment valve, and hold it for 5-10 minutes, let the high pressure gas fully open the air hole, and then adjust the fine adjustment valve to normal gas output.Basic parameters:Specifications / sizeStandard Edition:W05-05-12 (CO2 pipe diameter: inner diameter 4mm outer diameter 6mm) (water pipe diameter: inner diameter 12mm outer diameter 16mm)W05-05-16 (CO2 pipe diameter: 4mm inner diameter and 6mm outer diameter) (Water pipe diameter: 16mm inner diameter and 22mm outer diameter)Bubble counter version:W05-05-12A (CO2 pipe diameter: inner diameter 4mm outer diameter 6mm) (water pipe diameter: inner diameter 12mm outer diameter 16mm) with bubble counting functionW05-05-16A (CO2 pipe diameter: inner diameter 4mm outer diameter 6mm) (water pipe diameter: inner diameter 16mm outer diameter 22mm) with bubble counting functionPurchase Notes1: Must use CO2 special high pressure pipeThe CO2 special air pipe is hard and cannot be pinched by hand. If it is an opaque hose, it cannot be used.2: installation locationThe recommended installation position is within 1M from the water outlet, and the more air bubbles are near the water outlet3: There are many bubbles in the use of this product,