Sell ✽✔❅AIYIMA 20A Single Power Rectifier Filter Board 50V 63V 80V 100V 10000uF Schottky Rectifier Filter best price

This board is a single power supply high current rectifier filter circuit, compatible with single power supply or dual power supply transformers. The output of the board is indicated by LEDs. It can install 4 capacitors with a maximum diameter of 35mm and a pitch of 10mm. The kit with capacitors is equipped with 4 10000uF NOVER gold-character audio dedicated fever capacitor, capacitor voltage has 4 kinds of 50V/63V/80V/100V for choice. The rectifier adopts 4 MBR20200CT 20A 200V high-current dual-tube encapsulated Schottky diodes, and the internal resistance is lower after the internal tubes are connected in parallel. High-current input and output terminals, with EPCOS high-frequency filter and fever capacitors on the output end, suitable for single-supply power amplifier boards such as 1969 Xiaojia. The circuit board adopts tin-sprayed double-sided glass fiber board, and large-current large copper wiring, which is beautiful and generous. Capacitor version: 10000uF/50V, 10000uF/63V, 10000uF/80V, 10000uF/100V 4 kinds for choice. PCB size: length 135mm/width 72mm. Board height (including 10mm fixed copper pillar): 37mm without filter capacitor, 47mm with 50V filter capacitor, 62mm with 63V filter capacitor, 82mm with 80V filter capacitor, 92mm with 100V filter capacitor. The matching NOVER large filter capacitor polarity discrimination: the pin with the black dot is the negative pole The output of the board is a single DC power supply, and two sets of wiring sockets are designed on the output end, which are connected in parallel. In order to facilitate the connection of two power amplifier boards at the same time, it is not a dual power supply. Note: 1. The input can be connected to a dual power transformer (K disconnected) or a single power transformer (K short connected). The connection method of point K should not be mistaken. If the Schottky tube and transformer are connected incorrectly, they will heat up until they burn out! ! ! ! ! Another: K points of the finished board are all disconnected by default. 2. When a single power supply is input, the two output wires of the transformer are connected to the two ACs of the input socket of the board, and the GND in the middle is not connected. In the case of dual power input, the three output wires of the transformer are connected to AC GND AC. Please don't connect it wrongly, it may burn the transformer or bridge pile. 3. Jumper K: When the single power supply is input, the jumper K is connected, that is, K is short-circuited. When dual power input, jumper K is not connected, that is, K is open. Please don't connect it wrongly, it may burn the transformer or bridge pile. Package included: 1PCS Precautions: *** "Pre-sale" ***The products are shipped abroad, and the logistics time limit is generally about 15 days. If you mind, please don't place an order &&&Pre-sale products as long as they are shipped overseas, please do not refuse to sign at will, thank you ve