Sell 70mai M500 Dashcam | Built-in GPS | eMMC Built-in Storage up to 128GB with 24hrs Surveillance best price

•170° Wide Angle •1944P Ultra Full HD Video •Automatically Emergency Recording •ADAS Driving Safety System •Loop Recording •Time-Lapse Recording •App & Voice Control •Built-in GPS •Built-in Memory Storage Installing the electrostatic sticker Clean your windshield and put the electrostatic sticker on the recommended area as shown in the figure. Avoid the edge of the windshield and select the flat and smooth area for the installation. Make sure you remove air bubbles between the sticker and the glass. Inserting the dash cam to the bracket Insert the dash dam into the bracket with the power port facing inside until you hear a click sound. And then the dash cam is well installed. Connecting the power cord Connect the power cord to the Type-C power port of the dasm cam. Pull the power cord to ensure that it is well connected. Pasting the bracket Rotate the mount of the bracket and make the heat resistant adhesive face toward the front windshield. Peel off the protective film from the heat resistant adhesive, and paste the bracket onto the electrostatic sticker in the dotted area. Press the bracket to make sure it is firmly attached on the electrostatic sticker Connecting the power supply As shown in the figure, run the power cord along the top of the windshield, down the A-pillar, and around the glove compartment, so that the power connector is near the cigarette lighter. Connect the power cord to the car charger, then plug the charger into the cigarette lighter socket. Adjusting the dash cam angle Connect the dash cam with the 70mai app following the instructions on the user manual. Turn on the dash cam and adjust the camera angle based on the preview screen on the app to ensure that the camera is facing the front of the vehicle.