Sell 36V 350W 12A XT30 Motor Controller For Scooter Electric Bicycle E-bike best price

Specification: Voltage: DC 36V Rated Power: 350W Undervoltage: 30V Current-Limiting: 12A （15A scooter could be used,but the speed would be slowly） Instruction: 1. Boot: Long press the boot (about 1s). At the same time, the buzzer sounds twice. 2. Shutdown: Press and hold 3s to shut down. At the same time, the buzzer sounds twice. 3. Light: In the power-on state, short press (within 1 second) once, turn on the front and rear lights, the headlights are always on, and the taillights are flashing. 4. Brake: Electronic brake + disc brakes. The tail light is long on the brakes. 5. Gear shift: The power-on state, the default is the low-speed file; press the button twice (press twice in one second) to switch the gear position; Green is low gear; red is high gear 6. Battery display: 33v-36v The first light is long 36v-37v one or two lights long bright 37v-38.5v one or two lights long bright 38.5v or more, one, two, three, four lights Low voltage alarm: The first light flashes when the battery is below 33V, and the buzzer sounds 6 times. 7. Low voltage alarm speed mode: The speed limit is about 15Km/h. When the power returns to 37V, the throttle must return to the initial position to release the low voltage and return to normal operation. 8. Constant speed cruise: The speed is stable for about 6 seconds to automatically start the cruise control; after the cruise is fixed, the throttle can be released; press the brake or push the throttle again to release the cruise control and enter the manual mode. 9. Speed: The low speed gear is 15±2km/h; the high speed gear is 25±2km/h. 10.Automatic shutdown: Automatically shut down 10 minutes after no operation. Power Display: 1) Voltage 38.2V-42V The first second third fourth fifth lights are always on 2) Voltage 36.6V-38.2V The first second third fourth light is always on 3) Voltage 34.5V-36.6V The first second third lights are always on 4) Voltage 32.8V-34.5V The first second light is always on 5) Voltage 31.5V-32.8V The first light is always on 6) Voltage 30-31.5V The last grid flashes 7) Turn-off of motor with voltage below 31V Error Code: 1) "E1" Motor Hall failure 2) "E2" MOS MOS fault or motor phase line short circuit fault 3) "E3" Brake failure 4) "E4" Handlebar failure 5) "E5" Undervoltage protection 6) "E6" Instrument/control communication failure 7) "E7" Overvoltage protection 8) "E8" Controller op amp failure 9) "E9" Stall protection Wiring Port Diagram: Power cord: big black red line Motor wire: blue wire/green wire/yellow wire Hall wire: red wire/yellow wire/blue wire/green wire/black wire Tail light wire: small red wire and black wire Software Burning line: green line/red line/black line Communication line: green line/blue line/black line/red line/yellow line Package Included: 1 XController